Pool Cage Door Replacement in Jacksonville, FL

A door with a straight, sound frame that simply needs new hinges, a new closer, or fresh screen can often be repaired for less than a full replacement. But once the aluminum extrusion itself is bent, corroded, or pulling apart at the corner keys, patch repairs rarely hold for long in Jacksonville's heat and humidity. Replacing the whole door as a unit resets the geometry so it swings, seals, and latches correctly again.

We start by removing the old door and inspecting the header and jamb for damage, since a bent frame member can throw off a brand-new door just as easily as the old one. The new frame is cut and assembled, hung on new hinges, fitted with a self-closing hinge or door closer if you want one, and screened with spline set into the extrusion channel. The latch and strike are adjusted last so the door closes flush without being forced.

For pool cages that see heavy pollen or oak tree drop in spring, a self-closing hinge paired with a tight-fitting new door frame also cuts down on the debris that gets tracked or blown into the pool area every time the door is left ajar. That is a small detail, but it adds up over a full pollen season along the St. Johns River corridor.

Pricing depends on door size, whether the existing frame and header are reusable, mesh upgrade choices, and hardware such as closers or double doors for equipment access. A single swing door replacement is generally less involved than a double-door equipment gate. We can give you a firm number after seeing the door and frame condition in person, since hidden corrosion or a racked header can change the scope.

If your pool cage has more than one door, it is worth having all of them inspected at the same visit even if only one is currently causing problems, since doors installed at the same time tend to wear out on a similar timeline.

Homeowners near the coast sometimes ask whether a heavier-gauge frame is available for doors on the side of the cage facing prevailing wind. We can source a slightly heavier extrusion for that panel if the rest of the structure supports it, giving that entry point a bit more resistance to flexing during storm season.